Ok to use both EGP & BGP from same AS on T3 Backbone
Hi. A few weeks back this list was notified to cease peering with the NSFNET using both EGP and BGP from peers within the same AS. The T3 routing software now allows this configuration with no adverse side effects. However, please continue to avoid using both EGP and BGP to peer with the T1 NSFNET (from the same AS). Thanks. --Steve Widmayer Merit/NSFNET ***********************************************************************
Date: Tue, 2 Jun 92 10:19:22 EDT From: skw To: regional-techs Subject: Please avoid EGP & BGP backbone peering from the same AS...
Hi. Some NSFNET sites are configured to run both EGP and BGP sessions with the NSFNET from the same AS at the same time. Please avoid this practice and run only one or the other until further notice. We have discovered lost routes and black holing of traffic on the T3 backbone under such a configuration.
An excerpt from Curtis Villamizar <curtis@ans.net>:
Subject: mixing BGP and EGP at the same metric
The problem arises when there is an EGP route and one or more alternate routes with equal policy metric (either EGP or BGP) and the EGP route is favored. If the favored EGP route is lost and an alternate BGP route with the same metric exists, the alternate BGP route will always be advertised to the IBGP neighbors. If an alternate EGP route exists, it will not be advertised and will not be installed. Depending on which route is found first (hash table position dependent), the alternate route may not be installed. The more alternate routes at the same metric, the more likely you are to have this problem.
--Steve Widmayer Merit/NSFNET
participants (1)
-
skw