Cross connecting two routers with channelized interfaces
Hello, sorry for this dumb question. Is it possible to connect two routers like below ? RouterA/cstm1 ---- dark fiber ---- cstm1/RouterB The interfaces used in this case are channelized STM1 in both sides. Between RouterA and RouterB I would like to create many low-speed interfaces ranging from 64Kbps up to 2Mbps. Between these two routers there is no MUX. The framing mode has to be SDH. Thanks in advance! Diogo
Yes, u will have to connect the fibers in a cross manner..and setup one side to generate the clock.. Faisal On May 16, 2012, at 8:09 AM, Diogo Montagner <diogo.montagner@gmail.com> wrote:
Hello,
sorry for this dumb question.
Is it possible to connect two routers like below ?
RouterA/cstm1 ---- dark fiber ---- cstm1/RouterB
The interfaces used in this case are channelized STM1 in both sides. Between RouterA and RouterB I would like to create many low-speed interfaces ranging from 64Kbps up to 2Mbps. Between these two routers there is no MUX.
The framing mode has to be SDH.
Thanks in advance!
Diogo
Hi Faisal, I have tried the setup in my lab. I can get the cSTM1s UP and the controllers E1 up. But when I try to configure the subinterface, the protocol does not come online. Below is the configuration in one of the sides. The other side has similar configuration. controller SONET 4/0/2 framing SDH aug controller au-4-tug-3 ! controller AU-4-TUG-3 4/0/2.1/1 mode c-12 tug-2 1 e1 1 channel-group 0 timeslots 1 ! interface Serial4/0/2.1/1/1/1:0 bandwidth 64 ip address 10.1.1.1 255.255.255.252 encapsulation ppp load-interval 30 no fair-queue end Thanks Diogo On Wed, May 16, 2012 at 8:23 PM, Faisal Imtiaz <faisal@snappydsl.net> wrote:
Yes, u will have to connect the fibers in a cross manner..and setup one side to generate the clock..
Faisal
On May 16, 2012, at 8:09 AM, Diogo Montagner <diogo.montagner@gmail.com> wrote:
Hello,
sorry for this dumb question.
Is it possible to connect two routers like below ?
RouterA/cstm1 ---- dark fiber ---- cstm1/RouterB
The interfaces used in this case are channelized STM1 in both sides. Between RouterA and RouterB I would like to create many low-speed interfaces ranging from 64Kbps up to 2Mbps. Between these two routers there is no MUX.
The framing mode has to be SDH.
Thanks in advance!
Diogo
participants (2)
-
Diogo Montagner
-
Faisal Imtiaz