You might take a look on NetXray made by Cinco Networks that is now Network General that is now Network Associates... Ask Victor Amashta: victora@ngc.com www.ngc.com or www.nai.com

-----Original Message----- From: Jean-Lou Dupont Sent: 18 mars, 1998 16:02 To: Stephan Chayer Subject: FW: IP Generation program/devices

---------- From: Lewis Eatherton[SMTP:eathertl@segasoft.com] Sent: Wednesday, March 18, 1998 12:39 PM To: David J. Schmidt; Michael F Sullivan Cc: nanog@merit.edu Subject: Re: IP Generation program/devices

Also, you might want to take a look at Anvil, from Mightnight Networks. Its a very nice tool that runs on various Unix flavors and will test just about any part of the RFC on what ever protocols you order...

At 11:25 PM 3/17/98 -0800, David J. Schmidt wrote:

...

On Tue, 17 Mar 1998, Michael F Sullivan wrote:

...

To do some load testing, we need a "tool" (h/w device and/or s/w) to generate a programmable amount of IP traffic on a segment (say 32Mbps on a fast enet segment or fddi ring) and a way to measure it (w/ hopefully something cheaper than a sniffer). Anyone have suggestions on what to use?

Thanks

For the high end try Netcom Systems SmartBits.

Their systems can hold various interface cards (from 10-20 per chasis) and you can run up to 4 chassis in a stack.

We are using them to fully stress test our Gigabit Bridge/Router and I've been running tests with 24 gigabit cards into our device and we're also using their 10/100mb cards to test our 10/100mb cards.

The software can generate various IP frames from templates or you can use a raw packet editor.

NOT cheap! But it can generate and receive/trigger/count at full speed if that's what you need.

David.Schmidt@ior.com Packet Engines, Inc. (509)922-9190 Spokane, Washington http://www.packetengines.com/

Lewis Eatherton Network Architect SegaSoft, Inc 650.654.2318