Hi, following only the required configuration of https://www.juniper.net/documentation/en_US/junos/topics/task/configuration/... for # Configuring MACsec Using Static Connectivity Association Key (CAK) Mode works fine for two switches, but with a third EX4300 in the middle not. Thus, could anyone please help what is required to ensure connectivity through three EX4300?  Even the configuration (A; with several tries) on the outer sides switches such as e.g. given for (one port) per switch jack@cs2# set security macsec connectivity-association ca1 mka eapol-address provider-bridge   jack@cs2# set security macsec connectivity-association ca1 mka eapol-address lldp-multicast       jack@cs2# set protocols layer2-control mac-rewrite interface ge-0/0/13 protocol ieee8021 worked not for the three EX4300. Tunneling through a EX4200, in the middle (via vlan, snippet see below) worked fine, even without the   configuration (A) at the outer sides switches, only with the most important commands given in https://www.juniper.net/documentation/en_US/junos/topics/task/configuration/.... Any idea why tunneling through the middle EX4300 failed? (Used version: 17.3R3-S9.3!) Regards, Jack # PS: What is the equivalent code for EX4300 from the EX4200 code        vlan-id 55;          dot1q-tunneling {            layer2-protocol-tunneling {                all;            }