Is it just me or is the warm-reload feature not includet in 12.3(2)T1? As seen on Cisco CCO 12.3T Release Notes: Warm-Reload 12.3(2)T This feature was introduced. ^--- !!! 12.2(18)S This feature was integrated into Cisco IOS Release 12.2(18)S. Some Output: ip6.of#sh ver Cisco Internetwork Operating System Software IOS (tm) 7200 Software (C7200-JK9O3S-M), Version 12.3(2)T1, RELEASE SOFTWARE (fc2) ^--- !!!!! ip6.of#conf t Enter configuration commands, one per line. End with CNTL/Z. ip6.of(config)#w? % Unrecognized command Cisco CCO Release Notes: SUMMARY STEPS 1. enable 2. configure terminal 3. warm-reboot [count number] [uptime minutes] ^---- !!!!!!!!!!! 4. exit 5. show warm-reboot Kind Regards, Timo -- Timo Mohre / Network Engineer / Tiscali Germany Business Division / Robert-Bosch-Strasse 32 / D-63303 Dreieich Fon: +49(0)6103-916 930 / Fax: +49(0)6103-916 099 www.tiscali.de / www.tiscali-business.de / timo.mohre@de.tiscali.com