Hi

https://www.juniper.net/assets/kr/kr/local/pdf/books/tw-hardening-junos-devices-checklist.pdf

http://62.210.157.99/juniperdayone/TW_Hardening_Junos_Devices.pdf

Cheers

Pierre

Le jeu. 8 oct. 2020 à 16:59, Mann, Jason via NANOG <nanog@nanog.org> a écrit :

If using loopbacks on the router you have to have a firewall filter on it to permit traffic to the device even if you have a firewall filter on individual interfaces that would allow/deny traffic

 

From: NANOG <nanog-bounces+jamann=mt.gov@nanog.org> On Behalf Of Forrest Christian (List Account)
Sent: Thursday, October 8, 2020 3:38 AM
To: nanog list <nanog@nanog.org>
Subject: [EXTERNAL] Juniper configuration recommendations/BCP

 

<ISP hat on>

After nearly 30 years of being a cisco shop, I'm working on configuring our first pair of Juniper MX204's to replace our current provider-edge cisco. 

 

I've worked through enough of the Juniper documentation/books to have a fairly good handle on how to configure these, but I wanted to check with the list to see if there are any Juniper-Specific gotchas I might run into that isn't documented well.  

 

I've done a bit of googling and am either finding stuff that is largely Cisco-specific or which is generic - all of which I'm rather familiar with based on my past history.   Is there anything I should worry about which is Juniper-specific?

 

--

- Forrest