I’m trying to run netflow on one of our Cisco core routers (SUP720-3BXL), but I think I am hitting some limitations because of this: %EARL_NETFLOW-SP-4-TCAM_THRLD: Netflow TCAM threshold exceeded, TCAM Utilization [99%] The setup of netflow looks like this: ip flow-cache entries 524288 mls aging fast time 5 threshold 32 mls aging long 300 mls aging normal 60 mls netflow usage notify 80 300 mls flow ip full no mls flow ipv6 mls nde sender version 5 no mls verify ip checksum no mls acl tcam share-global ip flow-export source Loopback0 ip flow-export version 5 origin-as ip flow-export destination <ip> <port> Then I have this enabled on all border interfaces/vlans (peering / transit / other core routers) that are of interest for my stats: ip route-cache flow Some more details about the problem: #sh mls netflow table-contention detailed Earl in Module 5 Detailed Netflow CAM (TCAM and ICAM) Utilization ================================================ TCAM Utilization : 100% ICAM Utilization : 13% Netflow TCAM count : 262033 Netflow ICAM count : 17 Netflow Creation Failures : 4822220 Netflow CAM aliases : 1 #sh mls netflow table-contention aggregate Earl in Module 5 Aggregate Netflow CAM Contention Information ============================================= Netflow Creation Failures : 130003616 Netflow Hash Aliases : 4 I understand that the TCAM is full, but what can I do against it? This is a busy core router: Aggregated traffic: 7-8 GBIT/s Packets per Second: 1.0 - 1.2 Million I wouldn't mind analyzing only every 10th or 100th flow, which seems to be a common practice. Any good piece of advice is welcome. Thanks! - Andy