I have a network with two upstreams that land in datacenters many miles apart. The hardware involved is Cisco 7507s with RSP4s and VIP4-80. I've got a curious problem which I hope others here have faced. A while ago we got a /28 from each provider and attached it to a dedicated fast ethernet interface at each location. Inbound traffic arrives normally and anything arriving on that port is policy routed to the upstream that provided the prefix. This was all well and good when it was a little firewall with a Linux machine behind it being used to check latency and do other diagnostics, but the sales people noticed it and have lined up a couple of opportunities to sell a service that would depend on our being able to receive and send traffic from blocks less than a /24. The policy routing works fine at low volume, but the RSP4 is rated to only do four megabits and I know they're going to exceed that. I can terminate this subnet on another router, wire that device into the 7507 with a crossover, and establish a BGP session. I'm wondering if there is a tidy way to set next hop in some fashion using route-maps such that all the marking would be done on the auxillary machine and the traffic passing through the 7507 would be CEF switched rather than process switched. -- mailto:Neal@layer3arts.com // GoogleTalk: nrauhauser@gmail.com IM: nealrauhauser