Mike, Are you sure you have enough inbound capacity to setup such a thing? Do you have RTBH setup for the final means of killing the attack? If you could get another set of circuits to feed this switch from your same providers, and they accept more specific announcements, you could use this to swing /32's or /128's to said dedicated links so it won't affect your clients traffic. -- Ryan Hamel Network Administrator ryan.hamel@quadranet.com | +1 (888) 578-2372 QuadraNet Enterprises, LLC. | Dedicated Servers, Colocation, Cloud -----Original Message----- From: NANOG <nanog-bounces+ryan.hamel=quadranet.com@nanog.org> On Behalf Of Mike Hammett Sent: Tuesday, November 06, 2018 11:47 AM To: Lotia, Pratik M <Pratik.Lotia@charter.com> Cc: 'nanog list' <nanog@nanog.org> Subject: Re: Switch with high ACL capacity The intent is to see if I can construct a poor man's DDOS scrubber. There are low cost systems out there for the detection, but they just trigger something else to do the work. Obviously there is black hole routing, but I'm looking for something with a bit more finesse. If I need to get a switch anyway, might as well try to take advantage of it for other uses. -----Mike HammettIntelligent Computing SolutionsMidwest Internet ExchangeThe Brothers WISP ----- Original Message ----- From: Lotia, Pratik M <Pratik.Lotia@charter.com> To: Mike Hammett <nanog@ics-il.net>, 'nanog list' <nanog@nanog.org> Sent: Tue, 06 Nov 2018 12:29:15 -0600 (CST) Subject: Re: Switch with high ACL capacity Mike, Can you shed some light on the use case? Looks like you are confusing ACLs and BGP Flowspec. ACLs and Flowspec rules are similar in some ways but they have a different use case. ACLs cannot be configured using Flowspec announcements. Flowspec can be loosely explained as 'Routing based on L4 rules' (there's a lot more to it than just L4). I doubt if a there is a Switch which can hold a large number of Flowspec entries. ~Pratik Lotia “Improvement begins with I.” On 11/6/18, 10:39, "NANOG on behalf of Mike Hammett" <nanog-bounces@nanog.org on behalf of nanog@ics-il.net> wrote: I am looking for recommendations as to a 10G or 40G switch that has the ability to hold a large number of entries in ACLs. Preferred if I can get them there via the BGP flow spec, but some sort of API or even just brute force on the console would be good enough. Used or even end of life is fine. -----Mike HammettIntelligent Computing SolutionsMidwest Internet ExchangeThe Brothers WISP E-MAIL CONFIDENTIALITY NOTICE: The contents of this e-mail message and any attachments are intended solely for the addressee(s) and may contain confidential and/or legally privileged information. If you are not the intended recipient of this message or if this message has been addressed to you in error, please immediately alert the sender by reply e-mail and then delete this message and any attachments. If you are not the intended recipient, you are notified that any use, dissemination, distribution, copying, or storage of this message or any attachment is strictly prohibited.