Frank, We have had good luck with a device called TemPager (http://tempager.com/). Our specific device is used for SNMP temperature monitoring, but they also make a device that includes the ability to humidity, power, flood, room entry, etc. etc. Hope that is helpful, Josh - - - - Joshua Fiske '03, '04 Network and Security Engineer Clarkson University, Office of Information Technology (315) 268-6722 -- Fax: (315) 268-6570 GPG Key: http://clarkson.edu/~jfiske/jfiske_pub.asc jfiske@clarkson.edu CONFIDENTIALITY: This e-mail (including any attachments) may contain confidential, proprietary and privileged information, and unauthorized disclosure or use is prohibited. If you received this e-mail in error, please notify the sender and delete this e-mail from your system. -----Original Message----- From: Frank Bulk [mailto:frnkblk@iname.com] Sent: Fri 5/30/2008 10:58 AM To: nanog@nanog.org Subject: Power/temperature monitoring Hopefully monitoring the status of a network is on-topic. I'm looking for temperature and power monitoring unit to install in some remote BWA cabinets. We had two incidents where we lost power in a town and we weren't aware of it until the backup batter drained to empty, and another situation where the cabinet became too cold. Because these cabinets are less than 19" wide and just 3-5" deep, I need something quite small. I did find one product but it requires four components (unit with built-in temperature sensor, adapter, and AC power sensor, plus power supply) Perhaps there's someone on this list who has gone down this road and can point me to a good product. Required: - temperature sensor - 110 VAC power monitoring (on/off, not necessarily current) - Ethernet interface (at least SNMP, Web GUI and Optional: - fed via 12 VDC power - 12 VDC power monitoring (current) - humidity sensor Frank