I have seen DDR2 RAM give random errors from inadequate cooling. The cabinets were stacked to the max with severs but the doors were not meshed. DDR2 run fairly hot, especially when all the banks are filled. Tri Tran -----Original Message----- From: Jay Ashworth <jra@baylink.com> Date: Wed, 10 Jul 2013 00:04:23 To: NANOG<nanog@nanog.org> Subject: Re: What to expect after a cooling failure ----- Original Message -----
From: "Erik Levinson" <erik.levinson@uberflip.com>
For those who have gone through such events in the past, what can one expect in terms of long-term impact...should we expect some premature component failures? Does anyone have any stats to share?
If the HDDs were spinning while above rated maximum ambient intake temp, *especially* if they're not *right out front in the intake path* (is anything not built that way anymore? Yeah; the back side of 45-drive Supermicro racks, among other things), you should probably plan on doing a preemptive replacement cycle, or at the very least, pay *very* close attention to smartctld, and have a good stock of pre-trayed replacements. Remember that you may fall in the RAID Hole if you wait for failures, and hence lose data which isn't backed up anyway -- if more drives in a raid group fail *during rebuilds*, you're essentially screwed. If your raid groups were properly dispersed across drive build dates, then this will probably be *slightly* less dangerous, but still. Also watch bearing-type fans. Cheers, -- jra -- Jay R. Ashworth Baylink jra@baylink.com Designer The Things I Think RFC 2100 Ashworth & Associates http://baylink.pitas.com 2000 Land Rover DII St Petersburg FL USA #natog +1 727 647 1274