In message <4CBF9B7A.1000500@matthew.at>, Matthew Kaufman writes:
On 10/20/2010 6:20 PM, Mark Smith wrote:
To make it clear, as it seems to be quite misunderstood, you'd have both ULA and global addressing in your network.
Right. Just like to multihome with IPv6 you would have both PA addresses from provider #1 and PA addresses from provider #2 in your network.
Only nobody wants to do that either.
Only because there isn't good support for it yet. ULA + PA actually works today. The IP stack can do the address selection without worrying about reachability. The chances of the ULA being unreachable and the PA being reachable between two nodes in the same ULA prefix are negligable. If I'm talking to a ULA address I'll use my ULA address. If I'm talking to a non-ULA address I'll use my PA addresses. PA + PA is a problem because you need to worry about source address selection and that is driven by reachability. You also need to worry about egress points due to source address filtering. etc.
Matthew Kaufman -- Mark Andrews, ISC 1 Seymour St., Dundas Valley, NSW 2117, Australia PHONE: +61 2 9871 4742 INTERNET: marka@isc.org