That's what I thought. Our total inbound bandwidth from upstreams is about 20G at max.. so that really is the total bandwidth... Now we are terminating about 1800 PPPoE sessions on the router as well, and have policing set on them, as well as shaping on a couple of our major downstream links. Is anyone interested in making a few $ and taking a look for us, to see if we are really hitting capacity, or if some sort of tuning could be done to help us eak out a little bit more from this device before upgrading. --- Colin Legendre On Tue, Dec 7, 2021 at 10:34 AM Blake Hudson <blake@ispn.net> wrote:
On 11/26/2021 1:09 PM, Colin Legendre wrote:
Hi,
We have ...
ASR1006 that has following cards... 1 x ESP40 1 x SIP40 4 x SPA-1x10GE-L-V2 1 x 6TGE 1 x RP2
We've been having latency and packet loss during peak periods...
We notice all is good until we reach 50% utilization on output of...
'show platform hardware qfp active datapath utilization summary'
Literally ... 47% good... 48% good... 49% latency to next hop goes from 1ms to 15-20ms... 50% we see 1-2% packet-loss and 30-40ms latency... 53% we see 60-70ms latency and 8-10% packet loss.
Is this expected... the ESP40 can only really push 20G and then starts to have performance issues?
I haven't experienced that across about a dozen ASR 1ks. Though I just checked and we are not pushing any of our ESP's over 50% currently (the closest we have is an ESP 40 doing 18Gbps). However, I'm pretty sure we've pushed older ESPs (5, 10's, and 20's) to ~75% or so in the past.
Given the components you have, I would have expected your router to handle 40Gbps input and 40Gbps output. That could either be 40Gbps into the 6 port card [and 40Gbps out of the four 1 port cards] or it could be 40Gbps input that is spread across the 6 port and 1 port cards [that is then output across both cards as well].
Despite other comments, I think your components are well matched. The only non-obvious thing here is that the 6 port card only has a ~40Gbps connection to the backplane so you cannot use all 6 ports at full bandwidth. I think this router is well suited to handle 20-30Gbps of customer demand doing standard destination based routing (if you're doing traffic shaping, NAT, tunnelling, or something else more involved than extended ACLs you may need something beefier at those traffic levels).