Hello Nanog, I'm fairly new to running my employers multihomed BGP network with our own ASN. Things have been relatively smooth and stable for the past few months. We have 2 upstream ISP's giving us full routes. We have a single link to each provider, but I run two BGP sessions over that single link so I can have router redundancy. My routers are run in an active-passive configuration. With ISP-A, they have configured our 2 BGP sessions such that the secondary session (our passive router), although the BGP session is up, no traffic is directed there unless the primary router's BGP session goes away. This prevents asymmetric routing problems with my active/passive config. ISP-A attributes this config to the fact that we have 2 sessions, but on the same router, with a config on their router that looks like this: #show <http://r04.lsanca03.us.bb#show> running-config interface tenGigE 0/1/0/7 interface TenGigE0/1/0/7 description: 10GbE service-policy input cust1-in service-policy output cust1-out ipv4 address xxx.xxx.xxx.xxx 255.255.255.252 ipv4 address xxx.xxx.xxx.yyy 255.255.255.252 secondary ipv4 verify unicast source reachable-via any allow-self-ping ISP-B says they aren't able to do this active/passive config without us getting 2 physical links (kind of opposite what ISP-A is saying) They recommend that we use local pref and communities to direct traffic to our primary BGP session and only using the secondary session if the primary fails. Does that recommendation make sense? Will setting the local pref via ISP-B community strings accomplish this active/passive traffic split that I'm looking for? Looking through the documentation on this providers site about which community string needs to be set, it seems like I just need to make the primary router BGP session community string higher than the default, and the passive router BGP session community string lower than the default and that will get me the desired behavior. Is that the proper way of achieving the traffic flows for active / passive config from provider to my gear? Thank you, Philip