Platform: Cisco 7206VXR SW: Version 12.2(15)T2 router#sh run | b bgp router bgp 65011 no synchronization bgp log-neighbor-changes bgp confederation identifier 12345 bgp confederation peers 65001 65021 bgp deterministic-med bgp dampening network 1.2.3.0 mask 255.255.255.0 neighbor Confed-Peer-Group peer-group neighbor Confed-Peer-Group update-source FastEthernet1/1 neighbor Confed-Peer-Group next-hop-self neighbor Confed-Peer-Group version 4 neighbor Confed-Peer-Group soft-reconfiguration inbound neighbor Confed-Peer-Group filter-list 2 in neighbor Confed-Peer-Group filter-list 1 out neighbor 10.1.2.75 remote-as 65001 neighbor 10.1.2.75 peer-group Confed-Peer-Group neighbor 10.1.2.75 password 7 05211F2C105211F2C1666B neighbor 10.1.2.76 remote-as 65001 neighbor 10.1.2.76 peer-group Confed-Peer-Group neighbor 10.1.2.76 password 7 05211F2C105211F2C1666B no auto-summary router#conf t Enter configuration commands, one per line. End with CNTL/Z. router(config)#router bgp 65011 router(config-router)#neighbor 10.1.2.75 default-originate % Invalid command for a peer-group member router(config-router)# According to Cisco: All members of a peer group must share identical outbound announcement policies (such as distribute-list, filter-list, and route-map), except for default-originate, which is handled on a per-peer basis even for peer group members. I've also tried to apply to the peer group. The command is accepted, but no default origination of 0/0 is advertised to the peer(s). Thanks in advanced for any help, -=Vandy=-