Mark said: observed during RS/960 testing. The problem involved some aberrant behavior of rcp_routed when a misconfigured regional peer router would advertise a route via BGP to an ENSS whose next hop was the ENSS itself. The old rcp_routed could go into a loop sending multiple redirect packets out on to the subnet. The new rcp_routed will close the BGP session if it receives an announcement of such a route. The new rcp_routed software also has support for externally administered inter-AS metrics, an auto-restart capability, and bug fixes for BGP overruns with peer routers. This deployment caused a few problems. One is that this new feature of rcp_routed pointed out a misconfigured peer router at Rice University in Houston. This caused the BGP connection to open and close rapidly which caused further problems on the peer router. Eventually the peer was reconfigured to remove the bad route, which fixed the problem. Another problem was on the Argonne ENSS. This node crashed in such a way that it was ---------------------------------- What he did not say: The new rcp_routed will (virtually) immeadiately after the close, reopen a BGP session and pump all known routes at the BGP peer. If the peer is already working on processing the old ones, this adds an unneeded burden on the regional peer. I have not reviewed the spec in detail, but there should be something in place to prevent a constant cycle of close, open, slam 5k routes, close, open, slam 5k routes, close... well, you get the picture. This points out a configuration problem with BGP in the ANS T3 routers, in addition to the less than optimal configuration that we had in our ciscos. Just my two cents from the other side of the fence. -- Regards, Bill Manning bmanning@rice.edu PO Box 1892 713-285-5415 713-527-6099 Houston, Texas R.U. (o-kome) 77251-1892