Hi, We have a small ISP customer that wants to run a circuit to another local ISP and the ISPs would use that pipe only in the case of primary link failure. The two ISPs would split the cost, etc. The obvious solution would be for both ISPs to set up BGP peering with their upstreams and not announce anything in normal operation. The upstreams would continue to statically route the smaller ISPs' blocks and the smaller ISPs would default to their upstreams. The smaller ISPs would also put in a default pointing at each other with a higher cost. Then in the case of primary link failure the ISP who still has a path to the net would begin announcing the other ISP's block(s) to their upstream. The upstream would in turn see this as a valid announcement and propagate it to the world. Therefore specificity should draw all the traffic to the correct place. The problem is both ISPs are small and have /24s from their providers. The /24s would be filtered by many, leading to only partial connectivity in the case of failure. (Partial connectivity is better than no connectivity, I guess...) Another possible solution I thought of is to use NAT. The small ISPs would use RFC1918 internally and use a block from their provider to translate into. When the primary link fails they switch over to using a block from the other ISP's provider. They would also have to use very low TTLs for their DNS zones and be prepared to switch the DNS zones to point to the other block. Does the NIC consider this efficient utilization to have a block lying around that only gets used when a link fails? An important thing to remember here is that the backup link will not be used in normal operation. This is not multihoming. They do not want load balancing. I would be interested to hear others' thoughts on this. If you reply privately I will summarize any interesting replies to the list. Thanks! pbd -- You can make it illegal, but you can't make it unpopular.