On Fri, Nov 17, 2006 at 06:44:11AM -0800, Philip Lavine wrote:
To all,
Probabaly the the latter; however here is the situation. I am advertising a rte 1.1.1.1 via BGP to the Internet via ISP_A via my location in NJ. At my other location in CA where I am advertising another rte 2.2.2.2 via BGP to the Internet via the same ISP_A. I am using the same AS for both routes.
For some reason on my rtr advertising the 2.2.2.2 rte I am unable to see the 1.1.1.1 rte "% Network not in table". I know 1.1.1.1 rte is valid it shows up in looking glass and ISP_A has it on the peer 2.2.2.2 recevies full Internet rtes from. Further verification: I add a static rte on 2.2.2.2 rtr to 1.1.1.1 and its routable???
How is this possible? I have the following filters but I removed them and it seems to not make a diff. OUTBOUND - ip as-path access-list 1 permit ^$ ip as-path access-list 1 deny .* INBOUND - ip as-path access-list 2 permit .*
you will not accept a route with your AS in teh path you can override it (on cisco) with allow-own-as Steve