On Tue, Jan 30, 2007 at 08:04:25PM -0000, Mark D. Kaye wrote:
Hi,
PIX/ASA Supports IPv6 Apparently, see below.
Don't know anyone who has tested it yet though ;-)
http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_ chapter09186a0080636f44.html
"Note Failover does not support IPv6. The ipv6 address command does not support setting standby addresses for failover configurations. The failover interface ip command does not support using IPv6 addresses on the failover and Stateful Failover interfaces." "The following inspection engines support IPv6: * FTP * HTTP * ICMP * SMTP * TCP * UDP" as opposed to 23 separate "application inspection engines" listed in a table later on. Granted, some of those protocols don't exist on IPv6, but hardly 17 of 23. -- Joe Yao ----------------------------------------------------------------------- This message is not an official statement of OSIS Center policies.