On Thu, 26 Sep 2002, ip dude wrote:
When designing an all IP network requiring mostly Ethernet interfaces, the logical conclusion is to specify layer 3 switches (instead of routers). The cost per port and functionality requirements make a layer 3 switch the perfect choice.
I dont see this logical conclusion? My home network is all ethernet and my Netgear hub does a fine job! First questions would be how large is this network in terms of interfaces and traffic flows and how is it distributed. If its small use cheap L2 switches, if its on one or a couple of sites with not many hosts why do you need L3 in there at all, stick to L2.. If its larger and more distributed then you need to aggregate up anyway so I'd imagine its cheaper to use plain L3 routers connecting the L2 LAN across intersite WANs Needs more quantifying to find any conclusion but I dont see that an "all IP network" requires a L3 switch network!
However, the rule of thumb in the IP community is that routers are superior to layer 3 switches and should be utilized instead, especially when considering core type functionality.
I think we have a terminolgy issue here.. assuming a L3 switch is a device which uses routing decisions to influence a switching process then you get this on current Cisco routers.. the L3 makes the routing decision on the first packet in the stream but then additional frames are switched. But that aside I think you mean what vendors call "L3 switches or L4 switches" which are like a L2 switch but go into higher layer protocols to influence the switching decision and perform other features most commonly load balancing.
Does this rule of thumb still apply considering the modern layer 3 switches available? If not, why? What makes a layer 3 switch sub-standard to a pure router? Any quantitative analysis you could provide would be greatly appreciated.
Most commonly seems to be interoperability, the switches do their own job fine in their own isolated environment but they cant act as a "ISP router".. in my experience then tend to have odd bugs and behave slightly unexpectedly when say for example routing OSPF or BGP. Altho this is probably a chicken and egg - if more people tried to use them perhaps the vendors would fix the code!
I realize your answer may depend on device position within the network. I am comparing a router to a layer 3 switch as a core routing device, an EBGP border router and access device. Remember, my network is comprised of mostly Ethernet interfaces (FW, GE) and the occasional DS1 and DS3 interface.
Steve
Any opinions would be great.
Cheers!
Asand Bijaka
_____________________________________________________________ Get your own free Ranch eMail and Classified Ads at http://cattletoday.com
_____________________________________________________________ Select your own custom email address for FREE! Get you@yourchoice.com w/No Ads, 6MB, POP & more! http://www.everyone.net/selectmail?campaign=tag