On 6/8/21 2:38 PM, Fran via NANOG wrote:
Hey,
to my knowledge there is no IPv6 equivalent for net.ipv4.conf.all.rp_filter.
Therefore I use netfilter to do the RP filtering for both address families.
ip(6)tables -t raw -I PREROUTING -m rpfilter --invert -j DROP
Using the raw tables less resources are used, but you could also choose other tables. Details abour rpfilter can be found here [1].
This can also be achieved using nftables [2].
I've been in discussions on how to filter packets with bad source addresses on several mailing lists, including this one. For the last few weeks, I've been search for all the information I can find for how Linux implements rp_filter...which appears to have some holes. Looking at /proc/sys/net/ipv6, there is no knob for rp_filter, so if your system is IPv6 enabled you have to use the built-in firewall. For IPv4, I found kernel documentation, but it doesn't tell the whole story. For that, I had to comb the kernel sources to find out all the details of rp_filter. I've prepared a RFC letter of what I think I found, to be sent to the kernel developers. Here is the text of what I'll be sending, with any constructive criticism I get from here: Letter begins: After looking at the source that appears to implement rp_filter linux/net/ipv4/fib_frontend.c I believe that I now understand the tests rp_filter performs to validate the source address when net.ipv4.conf.*.rp_filter is set to one or two for a given interface. Does the new paragraph I have written accurately reflect what happens? If so, then I find out how to submit a patch to add the clarification to the kernel document. Description of rp_filter from https://www.kernel.org/doc/Documentation/networking/ip-sysctl.txt -------------------------------------------------------------------- rp_filter - INTEGER 0 - No source validation. 1 - Strict mode as defined in RFC3704 Strict Reverse Path Each incoming packet is tested against the FIB and if the interface is not the best reverse path the packet check will fail. By default failed packets are discarded. 2 - Loose mode as defined in RFC3704 Loose Reverse Path Each incoming packet's source address is also tested against the FIB and if the source address is not reachable via any interface the packet check will fail. [*new text here] Current recommended practice in RFC3704 is to enable strict mode to prevent IP spoofing from DDos attacks. If using asymmetric routing or other complicated routing, then loose mode is recommended. The max value from conf/{all,interface}/rp_filter is used when doing source validation on the {interface}. Default value is 0. Note that some distributions enable it in startup scripts. -------------------------------------------------------------------- Recommended addition where marked with "[*new text here]": rp_filter will examine the source address of an incoming IP packet by performing an FIB lookup. In loose mode (value 2), the packet is rejected if the source address is neither UNICAST nor LOCAL nor IPSEC. For strict mode (value 1) the interface indicated by the FIB entry must also match the interface on which the packet arrived.