On Mon, Oct 29, 2007 at 04:53:50PM -0400, Deepak Jain wrote:
You can "nail" down your announcements to external peers by tying their network blocks to a route-of-last resort on one of your loopbacks. This will prevent flapping externally.
Point taken, but it's actually difficult to nail down all of our routes. We have some lone /24's that are not subnetted and thus cannot be used with an 'ip route ... null0' statement. When WAN connectivity drops, the routes flap if we don't have a stable iBGP session. Thus I'd like to steer well clear of severing the iBGP session.
The weights can be added/removed automatically by using a route-map on the routes that will be added/removed by the interface going down.
Only a single internal /30 route will be removed when an interface goes down. I can't come up with a route-map implementation that would add/remove the weights to the routes already received from our eBGP neighbors. If I'm missing something, please let me know.
Normally, however, you wouldn't use iBGP for this and you'd use a heavier, link-aware internal routing protocol like ISIS or OSPF.
We use OSPF internally, but it just carries internal infrastructure addresses. I understand that OSPF is link-aware and can carry knowledge of link bandwidth, but I don't see how it would fit into our exit path policies. We accept full routes from our eBGP neighbors and it's not advisable to inject those into OSPF. Our normal policy must be best-exit, which leaves iBGP as the decision-maker unless I'm missing something. Is there a better IGP-based method of choosing a network exit path that would solve these problems? I ask because I'm curious, not because I know the answer. -- Ben Howell
Benjamin Howell wrote:
Is there a generally accepted method of automatically altering exit policies within an AS?
I'd like to dynamically change from best-exit to a "hot potato" exit policy when an internal DS3 fails. We fail over to a much lower bandwidth link and would like to avoid sending anything but internal traffic over that link. If it's not already clear, this change needs to happen automatically.
I realize that there are two means of accomplishing this:
(1) Set a weight on all routes received from the eBGP peer at each location so that it prefers the direct eBGP peer. (2) Sever the iBGP session by tying the iBGP session to an interface IP address rather than a loopback IP. When the DS3 goes down, so will the knowledge of the remote exit point.
The devil's in the details however. I can't figure out how to make the weight approach work on routes that were received prior to the circuit failure or how to remove the weights once the circuit comes back up.
Severing the iBGP session seems drastic to me, and I'm worried that our advertised routes will be dampened by peers if the internal DS3 starts flapping.
Any input from wiser peers would be greatly appreciated.
-- Ben Howell