On Thu, Feb 01, 2001 at 06:21:48PM -0500, Rodney Dunn wrote:
Danny,
The interface status should be independent of the swithcing path. I've never seen the line state be affected by the switching mechanism (although I have seen the opposite).
Can you email me the case# you had so I can take a look?
I have, because the line state can be controlled by the keepalive. If the keepalive don't get through because of the switching path .....
rodney
On Tue, Jan 30, 2001 at 02:22:21PM -0600, Danny Snyder wrote:
Ya got me on that one....Cisco didn't really say why and I didn't think to ask them either....
--Danny
-----Original Message----- From: Kenny Sallee [mailto:k_sallee@yahoo.com] Sent: Tuesday, January 30, 2001 11:28 AM To: agudgeon@firstnet.co.uk; 'Danny Snyder' Cc: nanog@merit.edu Subject: Re: More 6509 problems...
How would CEF cause an interface to be up/down? Just curious....Kenny
----- Original Message ----- From: "Alison Gudgeon" <agudgeon@firstnet.co.uk> To: "'Danny Snyder'" <dsnyder@nowdocs.com>; <nanog@merit.edu> Sent: Tuesday, January 30, 2001 8:36 AM Subject: RE: More 6509 problems...
Hi
Hybrid IOS
I've got IP CEF DISTRIBUTED set globally. Did you have it enabled or disabled on the T3 interface?
Ali
-----Original Message----- From: Danny Snyder [mailto:dsnyder@nowdocs.com] Sent: 30 January 2001 16:21 To: agudgeon@firstnet.co.uk; nanog@merit.edu Subject: RE: More 6509 problems...
Alison,
I've had VERY similar problems with a 6509 (Sup 1a + MSFC2) with a FlexWAN and a PA-2T3+. After spending the better part of two weeks on the phone with Cisco, we finally determined that ip cef distributed needed to be turned on in global configuration.
Also, are you running native IOS or Catalyst OS on the Supervisor and IOS
on
the MSFC ?
Danny Snyder Network Administrator NowDocs, Inc.
-----Original Message----- From: owner-nanog@merit.edu [mailto:owner-nanog@merit.edu]On Behalf Of Alison Gudgeon Sent: Tuesday, January 30, 2001 10:18 AM To: nanog@merit.edu Subject: More 6509 problems...
Hi,
Is anyone doing the following:
6509 (supervisor 1a + msfc) - with a flexWAN adapter to take a Packet Over Sonet OC-3 card.
I'm having great problems getting up/up on the interface, the current situation is up/down, a hardware loop at the telco kit brings the line up/up but otherwise just up/down. Config is default I've just put IP's on.
I'm running very new code - 12.1(4)E1
many thanks in advance for any help.
Kind Regards
Alison
-- Regards, Ulf. --------------------------------------------------------------------- Ulf Zimmermann, 1525 Pacific Ave., Alameda, CA-94501, #: 510-769-2936 Alameda Networks, Inc. | http://www.Alameda.net | Fax#: 510-521-5073