Do you have access to an Adtech or equivalent tester? Our AX4000 has the ability to fake a routing table. Just give it a range of prefixes and a range of prefix-lengths.
-----Original Message----- From: Jason Lewis [mailto:jlewis@packetnexus.com] Sent: Wednesday, July 09, 2008 9:55 AM To: NANOG list Subject: Re: Building a BGP test network
I should clarify that my test network is not connected to the Internet or any other network. I would normally just peer and get the table, but I don't have that ability. I'm open to anything that could act like a BGP router where I could feed it an existing RIB.
Jason Lewis wrote:
I'm building a BGP test network and I'd like to replicate a full route table on a few of my routers. I thought I might be able to use Quagga and insert a rib dump, but I'm not finding a lot of info on if it's possible. (I've pinged the quagga list and didn't get any response)
So my question is, is it possible to feed a router on a private test network a full route table from a RIB snapshot? I have to think someone has done it and I'm just not searching for the right things. Thanks,
jas
______________________________________________________________________ This email has been scanned by the MessageLabs Email Security System. For more information please visit http://www.messagelabs.com/email ______________________________________________________________________
NOTICE: This electronic mail transmission may contain confidential information and is intended only for the person(s) named. Any use, copying, or disclosure by any other person is strictly prohibited. If you have received this transmission in error, please notify the sender via e-mail.