Samir, I have purchased over a thousand SFPs from Fiber Store. I can recall less than 5 having problems when we received them (not all even DOA) and I know less than 10 dead even after deployment. Some we have ad running for 4+ years. We have done very little with their SFP+ equipment, really only testing and a few lower priority links. The only downside to the SFPs that we found was the variance of power. Say an Adtran, Cisco, Juniper, HP SFP is rated from -3dB to -8 db (all units I have used them with), the equivalent FS direct SFP we have seen as hot as 3dB and as weak as -15dB. These extremes are fairly rare but we have still seen them. Distribution (approximate): 80% SM single fiber SFPs (mostly 10km - 40km, some 60km & 80km) 7% 1Gb Copper 5% MM SFPs 5% SM dual fiber SFPs 3% others (SFP+, GPON, testing, etc) I have not used them for any DWDM applications and only used them a few times on an older CWDM link that used standard SFPs into a MUX. This was not over great distances (less than 40 miles). With WDM SFP power consistency was important so we did not play much with it, granted most of the SFPs I am purchasing are in the $10-$25 range so take the extremes with a grain of salt. Their sales has always been very responsive and helpful. The support/engineering, the few times I worked with them, were helpful but the language barrier was harder here. Brian ________________________________ From: NANOG <nanog-bounces@nanog.org> on behalf of Samir Rana <samir.rana@cybera.ca> Sent: Sunday, February 17, 2019 12:42 PM To: nanog@nanog.org Subject: fs.com dwdm equipment Hello All, Does anybody have experience with fs.com<http://fs.com> dwdm equipment in their production environment? Are you they working without any issue? How's their warranty support if the issue arises? Thanks in advance for all the answers and help.