Saku Ytti <saku@ytti.fi> writes:
On Thu, 8 Sept 2022 at 10:01, Bjørn Mork <bjorn@mork.no> wrote:
Why would you do it differently than for dual-stack routers, except that you skip the step where you configure the ID as a loopback address?
Because you may not have an option, if you're IPv6 only, vendors (e.g. junos) may expect you to punch it manually. Of course most of us punch it manually as loopback0 IPv4 to have more control over outcome. Question is legitimate and represents change where previously used mechanisms do not apply, therefore OP is right to ask 'well what should I do now'.
I'm not used to punching anything, so I probably have too simple a view of the world. But I still don't understand how this changes the ID allocation scheme, which is how I understood the question. I assume the punched value was based on input from somewhere? Bjørn