Your provider is likely backhauling the circuits opposite directions to PE routers in a different geographic local than the sites. It's time to have a discussion with your sales engineer about the physical pathing of your circuits and PE router locations. When I know I have latency critical circuits, I always insist on backhaul to the same geographic region and/or Pe. It's unlikely the MPLS or circuits themselves have anything to do with the latency, assuming this is T1, Ethernet, or similar. It's possible it could be a routing issue SP side, but is not as likely as a general pathing issue. On Thu, Nov 15, 2012 at 12:20 PM, Jared Mauch <jared@puck.nether.net> wrote:
On Nov 15, 2012, at 2:15 PM, Scott Weeks wrote:
--- mikeal.clark@gmail.com wrote: From: Mikeal Clark <mikeal.clark@gmail.com>
I have some AT&T MPLS sites under a managed contract with latency averaging 75-85 ms without any load. These sites are only 45 minutes away. What is considered normal/acceptable? --------------------------------------------
Coast-to-coast latency is around 60-65msec, so that's high.
What link speed?
Perhaps he's using ISDN or a T1?
Serialization delay is not to be ignored.
- Jared