
On 14/Sep/20 22:42, aaron1@gvtc.com wrote:
Oh snap! Hey hey, that's good, thanks Nick. I had to go into the locator service of the remote pe and find a sid that would respond to ping.
This is apparently an OAM Endpoint with Punt (End.OP)
https://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k-r7-0/se...
Here I'm executing ping/trace from the SRv6 ingress pe...to the egress PE
RP/0/RP0/CPU0:r1#ping fc00:0:4:4::1 source lo0 use-srv6-op-sid fc00:0:0:4:40:: Mon Sep 14 20:27:09.727 UTC Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to fc00:0:4:4::1, timeout is 2 seconds: SSSSS Success rate is 100 percent (5/5), round-trip min/avg/max = 329/371/416 ms
RP/0/RP0/CPU0:r1#traceroute fc00:0:4:4::1 source lo0 use-srv6-op-sid fc00:0:0:4:40:: Mon Sep 14 20:27:19.068 UTC
Type escape sequence to abort. Tracing the route to fc00:0:4:4::1
1 ::ffff:0.0.0.0 [IP tunnel: DA=fc00:0:0:4:40:: SRH Stack 0 =(fc00:0:4:4::1 ,SL=1) ] 29 msec [IP tunnel: DA=fc00:0:0:4:40:: SRH Stack 0 =(fc00:0:4:4::1 ,SL=1) ] 56 msec [IP tunnel: DA=fc00:0:0:4:40:: SRH Stack 0 =(fc00:0:4:4::1 ,SL=1) ] 12 msec 2 ::ffff:0.0.0.0 [IP tunnel: DA=fc00:0:0:4:40:: SRH Stack 0 =(fc00:0:4:4::1 ,SL=1) ] 118 msec [IP tunnel: DA=fc00:0:0:4:40:: SRH Stack 0 =(fc00:0:4:4::1 ,SL=1) ] 101 msec [IP tunnel: DA=fc00:0:0:4:40:: SRH Stack 0 =(fc00:0:4:4::1 ,SL=1) ] 99 msec 3 fc00:0:4:4::1 224 msec 277 msec 254 msec 4 ::ffff:0.0.0.0 237 msec 209 msec 204 msec 5 fc00:0:4:4::1 386 msec 431 msec 403 msec
Now I see this on the wireshark capture...
Ethernet - 86dd Ipv6 - DA fc00:0:0:4:40:: (cool, this is the active/top SID, and not the ping'ed DA) - routing header for v6 (segment routing) --- segments left: 1 --- address next segment: fc00:0:4:4::1 Icmpv6
My head hurts :-)... Mark.